At the Regent Titan Variable the wanted working width can be adjusted hydraulically during the drive from the tractor seat, whereby the front furrow and the traction point can be adapted automatically.
At the same time all pre-tools, disc-coulters and the depth wheel can be adjusted automatically.
Advantages of the
Titan plough technology
Frame swing system
FTS
The perfect solution –
the CX adjustment center
Advantages of the
Titan bearing technology
- Hydraulic working width adjustment per plough body.
- Optimal adaptation of the working width for different kinds of soil and land.
- The right working width for each furrow (small seed furrow up to the broad autumn furrow).
- Simple ploughing of wedge areas or obstacles.
The frame swing system FTS swings the frame of the plough to the centre of the tractor before the turning process without changing the adjusted cutting width. Hereby the lifetime of the bearing of the plough body is maximised and above all an overlapping of the priority axis with the rotary axis is achieved. The outcome is a turning process with strongly reduced loads for the headstock of the plough and for the tractor hitch.
Your advantages:
- Small width for street transport
- Frame swivelling without crossing the cutting width
- Overlapping of priority axis and rotary axis
- Increased security at turning (especial for hillsides)
- Decreased peak loads at the headstock
- Decreased peak loads at the tractor hitch
- Increased stability for a long lifetime
Simple adjusting for easy pulling ploughing
- Infinitely variable first furrow width adjustment of the first body with the C – spindle.
- Light adaptation to the different tractor tracks.
- No change of the traction point cause of the parallel shift.
- The traction point adjustment with the X – spindle cares for an ploughing free of side pulling.
- The traction point indicator secureds an optimal and light adjustment(independent from the first furrow width adjustment)
- The inclination angle is adjustable independently from both plough sides. „1“
- On cutting width change during the work the traction point is adjusted automatically.
(No creeping of the draft link resp. of the upper link to right or left)
- Greasing bearing pins, and the throughout bush secures a long durability.
- No additional drill holes for the frame reinforcement
- Each additional drill hole in the frame is a loss in stability.
- Few but great dimensioned links.
- Greasing bearing pin
- Throughout bush with grease channel
- Thick frame profile all models at least 10 mm
- Grease chamber with connection to the grease channel
- Additional strengthening of the frame in the area of borings
Ploughing free of side pull
On each working width
Memory cylinder „2“
Hydr. frame turning draw in
(option)
(Recommendable
as of 5 furrows)
